Features of Horizontal Strip Accumulator
The Reverse Loop Accumulator is installed between the shear & welder and the forming line. Its purpose is to give enough time for feeding the new coil from uncoiler to shear & welder and for the shear & welder to cut and join front end of the new coil with tail end of previous coil.
The accumulator is filled with strip, even during mill stop. The feature is useful when using smaller density coils. The accumulator has a high speed fill mode, synchronous (Mill Match) mode and jog mode, all controlled through PLC in the control panel.
Entry(Filling) Speed | 300 m/min |
Exit(Line) Speed | Max 100m/min, continuous operation |
Jog Speed | 15 m/min |
Accumulator Outer Dia | Approx 5.0 meters |
Line Direction | As per requirement |
Storage Capacity | 5.1 Minutes with coils of 16 Kg/mm width |
Main Drive Motors | 30 Kw x 1 Nos |
Pinch Rolls | 22 Kw x 1 Nos |
Pinch Roll Pressure | Pneumatic, solenoid operated |
Roll Direction | Vertical |
Roll Drive | Both Left & Right through distribution Gear Box |
Roll Material | Low alloy steel hardened |
Guide Rolls | Top and bottom edge guide rolls |
Storage table plate | Wear resistance high manganese steel |
Drive | Through a reducer gear box & pinion & Anti friction bearing with gear teeth |
Inner rolls | Idle rolls on the table Heat treated on the surface |
Take-out Helix | Twisted Idle rolls and frame construction with bottom guide rolls |
OD Rolls | Vertical rolls located on the outer diameter of the Storage table. |
Gear Box Ratio | 10:1 |
Exit guide rolls | Idle guide rolls and frame/plate construction |